I have been fabricating grommet panels and I was asked a question by a fellow fabricator on Facebook if there was a trick when laying out the grommet placements to be sure that the seam fell to the back of a grommet. The answer, yes there is. There needs to be an even number of grommets so that the returns fall back to the wall, and there needs to be an even number of grommets on each side of the seam for the seam to fall back to the wall. Another tip when spacing the grommets is: the center of the end grommets to the edge of the panel needs to measure what you want your return measurements to be.
Comments
Post a Comment